Wake The Lightsaber: To start the lightsaber, press and hold on the LED button (power button) on the hilt for 2 seconds.Note: All lightsaber functions are being performed via one single button, so each function changes by the number of red flashes which are being explained below. Keep it secure, but don’t over tighten the screw, since this could harm the saber’s blade or screw threads.The blade is sufficiently fastened if it is difficult to rotate. Encase it down slowly using the 2mm hex key included with the screw set. Insert the set screw into the drawn holes on the emitter’s side.Push the blade all the way in and keep it in place since contact pins in the emitter are spring-loaded. Place the blade into the emitter of the Neopixel lightsaber.A Neopixel lightsaber is required to use the Neopixel blade.Avoid pulling out the protective film from the chassis as it may cause a short circuit.Do not press your ear against the speaker. When inserting or removing the inner chassis, make sure the connecting pins are aligned properly.When dueling with a neopixel blade, please use caution since the guarantee does not claim to recover any destruction occurred to the blade during dueling and only covers craftsmanship.When the power is on, do not thrust or detach the blade. Please push the blade into the hilt until it wouldn’t go any farther.Flickers, wrong colors, or no light at all on the blade might be caused by a loose connection between the blade and the retention screw.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |